Our UFO style IP dome webcam is available in 1.3 megapixel or 3 megapixel options. They have a dual stream function so they can be used for security recording and a website stream at the same time if required. As with all our IP cameras they can operate with our live streaming service and we give a generous discount on our streaming service with every webcam purchased from us. The UFO design means that the fixings and cable entry into the building or suspended ceiling etc. are concealed once fitted. They can be used with a POE switch or with our POE injector or a 12 volt PSU (sold separately).
UFO style IP Webcam
Available in 1.3 or 3 Megapixel Versions
This camera can be powered directly from a POE router or POE switch. It can also be powered from a separate 12 volts DC supply. If you need a power supply or POE Injector click here.
UFO IP Camera 1.3MP Version Specification
Image Sensor: 1/3" Aptina CMOS
Resolution: 1.3 Megapixel
Effective Pixels: 1280 x 960
Scanning System: Progressive
Electronic Shutter Speed: Auto, Manual, 1/3-1/10,000s
Minimum Illumination: 0.05 Lux
S/N Ratio: >50dB
Analogue Video Output: No
IR LEDs: NO
IR Cut: NO
IR LED's: NO
Backlight Compensation: BLC, HLC, DWDR
White Balance: Auto, Manual
Gain Control: Auto, Manual
Noise Reduction: 3DNR
Privacy Masking: 4 Areas
Lens Size: 3.6mm
Max Aperature: F1.9
Focus Control: Fixed
Angle of View: 70° Horizontal
Lens Type: Fixed Iris
Mount Type: Board Lens
Compression: H.264, MJPEG
Resolution: 1.3MP, 720P, D1, CIF
Main Stream Frame Rate: 25fps @ All Resolutions
Sub Stream Frame Rate: 25fps @ D1/CIF
Bit Rate: 32k - 8192Kbps (H.264)
Audio Support: NO
Ethernet Type: RJ-45 10/100
Onvif Compatible: Onvif Profile S
Maximum Users: 20 Users direct access
Smart Phone Support: iOS, Android, Windows Phone
Micro SD Card Support: Yes 64GB max
Alarm Inputs: No
Alarm Outputs: No
POE: Yes - 802.3af
Input Voltage: DC12v, POE
Power Consumption: Max 4W
Working Environment: -20°C - +60°C <95% Humidity
IP Rating: IP66
Vandal Resistance: IK10
Dimensions: 110x54mm
Weight: 0.25kg
Our POE enabled IP cameras are not supplied with a power supply as you may wish to use them on an existing POE router or switch so this keeps the cost of the camera down. If you want to power the camera down the same network cable that connects to your existing router that is not POE enabled then you can use our POE Injector, or you can use a separate 12 volts DC 2 amp power supply if you wish instead. These can be found in our power supply section.
