Our true FTP IP Webcam is an excellent all round model. the FTP webcam has firmware installed giving It the ability to send images by Standard FTP to an FTP web site host at a timed interval and will over write the same image each time with the same name. This is ideal for web sites that do not need a real time stream but are happy to use a static image that updates every X number of seconds or minutes. So you can have, for example, a full 1080P HD image update on your web site every 30 seconds with nothing else needed but the camera set up and configured correctly and connected to your router.
Of course as with all our IP cameras this camera is ideal for streaming through our live streaming service for a real time live stream too so you can always update your web display to a real time feed later if you wish, or even use both in low bandwidth areas so you could live stream a lower definition stream while providing an HD static picture every minute or so which will use less over all bandwidth.
The camera also includes a built in MicroSD card slot (supports cards up to 128GB, SD card not included) for storing snapshots and video clips, has wired and wireless connectivity and can be operated over POE so can be used with a POE switch or with our POE adaptor or a separate 12 volt PSU (sold separately). IR range is 15 metres and camera is fitted with a 6mm lens. (Note this model is subject to a 5-10 day delivery to ensure correct firmware installation before shipping)
2 Megapixel FTP IP Webcam
£228.00 - Currently Out Of Stock
2 Megapixel FTP IP Camera Specification
Image Sensor: CMOS 1/2.7"
Resolution: 2 Megapixel
Effective Pixels: 1920 x 1080
Scanning System: Progressive
Min Illumination: 0.08Lux/F2.0(colour), 0.01Lux/F2.0(B/W)
S/N Ratio: >50dB
Built-in IR illuminators, Effective up to 15 meters
Lens Size: 6mm
Max Aperature: F2.0
Angle of View: 60° Horizontal
Compression: H.264, MJPEG
Max Stream Frame Rate: 18fps@ All Resolutions
Ethernet Type: RJ-45 10/100
Wireless IEEE802.11b/g/n
Frequency:2.412-2.462GHz
Security:WEP (64/128 bit), WPA-PSK(AES/TKIP), WPA2-PSK(AES/TKIP)
Transmission speed: 150Mbps/54Mbps/22Mbps/11Mbps/5.5Mbps/2Mbps/1Mbps (Auto Switch)
Onvif Compatible
Microcard support up to 128GB
POE: Yes
Input Voltage: DC12v or POE (PSU Not Included)
Power Consumption: Max 3.8W
Working Environment: -20° - +50° <95% Humidity
IP Rating: IP66
Dimensions: 7.5 x 2.8 x 2.8 inches
Weight: 4.2 pounds
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Maecenas et metus.
Our POE enabled FTP IP cameras are not supplied with a power supply as you may wish to use them on an existing POE router or switch so this keeps the cost of the camera down. If you want to power the camera down the same network cable that connects to your existing router that is not POE enabled then you can use our POE Injector, or you can use a separate 12 volts DC 2 amp power supply if you wish instead. These can be found in our power supply section.
If your web site is hosted on a web service that does not allow Standard FTP webcam upload then we can host the FTP IP camera image upload for you for just £1.99 per month. This will provide a domain locked image update that you can use in your own web pages with ease served via HTTPS from our servers to an unlimited number of viewers.