Our 1.3 Megapixel eyeball style IP webcam will stream in real time up to 720P and has a dual stream function so it can be used for security recording and a website stream at the same time if needed. As with all our IP cameras it runs great through our live streaming service and is small enough to be fitted almost anywhere. The eyeball design means that the fixings and cable entry into the building are concealed once fitted and its casing is very tough. There is also a cable entry in the side of its base if entry to the building cant be made from the rear of the camera. With a full 3 axis adjustment available it can be mounted on all angles of surface and you can still set up the picture with the correct orientation. Camera has POE so can be used with a POE switch or with our POE injector or a 12 volt PSU (sold separately)
1.3 Megapixel Mini Eyeball IP Webcam
£144.00
This camera can be powered directly from a POE router or POE switch. It can also be powered from a separate 12 volts DC supply. If you need a power supply or POE Injector click here.
1.3 Megapixel Eyeball IP Camera Specification
Image Sensor: 1/3" Aptina CMOS
Resolution: 1.3 Megapixel
Effective Pixels: 1280 x 960
Scanning System: Progressive
Electronic Shutter Speed: Auto, Manual, 1/3-1/10,000s
Minimum Illumination: 0 Lux
S/N Ratio: >50dB
Analogue Video Output: No
IR LEDs: Yes
IR Cut: Yes
IR LED Range: 20m
Backlight Compensation: BLC, HLC, DWDR
White Balance: Auto, Manual
Gain Control: Auto, Manual
Noise Reduction: 3DNR
Privacy Masking: 4 Areas
Lens Size: 2.8mm
Max Aperature: F2.0
Focus Control: Fixed
Angle of View: 89° Horizontal
Lens Type: Fixed Iris
Mount Type: Board Lens
Compression: H.264, MJPEG
Resolution: 1.3MP, 720P, D1, CIF
Main Stream Frame Rate: 25fps @ All Resolutions
Sub Stream Frame Rate: 25fps @ D1/CIF
Bit Rate: 32k - 8192Kbps (H.264)
Audio Support: No
Audio Compression: N/A
Audio Channels: N/A
Ethernet Type: RJ-45 10/100
Onvif Compatible: Onvif Profile S
Maximum Users: 20 Users
Smart Phone Support: iOS, Android, Windows Phone
Micro SD Card Support: No
Alarm Inputs: No
Alarm Outputs: No
POE: Yes - 802.3af
Input Voltage: DC12v, POE
Power Consumption: Max 4W
Working Environment: -20°C - +60°C <95% Humidity
IP Rating: IP66
Vandal Resistence: N/A
Dimensions: 114x86mm
Weight: 0.29kg
Our POE enabled IP cameras are not supplied with a power supply as you may wish to use them on an existing POE router or switch so this keeps the cost of the camera down. If you want to power the camera down the same network cable that connects to your existing router that is not POE enabled then you can use our POE Injector, or you can use a separate 12 volts DC 2 amp power supply if you wish instead. These can be found in our power supply section.
